 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| PSMPS30 Series Single Output Up to 30 Watts AC/DC Medical Power Supply FEATURES Low Cost High Reliability 3 Year Warranty Low Leakage Current 0.3mA Universal AC Input / Full Range Fixed Switching Frequency at 100KHz Protections: Short Circuit /Overload /Over Voltage /Over Temperature SPECIFICATIONS: PSMPS30 Series All specifications are based on 25 C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. INPUT SPECIFICATIONS Input Voltage 88 - 264VAC auto switch (127 - 370VDC) Input Frequency 47 to 63Hz AC Current (typical) 0.8A @ 115VAC / 0.5A @ 230VAC Inrush Current 30A @ 230VAC cold start Leakage Current Less than 0.3mA @ 264VAC OUTPUT SPECIFICATIONS Output Voltage See Table Output Voltage Tolerance 3% for all models except PSMPS-30-48 (2%) Output Power See Table Line Regulation 1% max. Load Regulation 1% for all models except PSMPS-30-5 (2%) Output Current See Table Ripple & Noise (20MHz BW) See Table Setup, Rise Time 500ms and 30ms @ 230VAC and full load / 500ms and 30ms @ 115VAC and full load Hold-Up Time 70ms @ 230VAC and full load / 12 ms @ 115VAC and full load. Temperature Coefficient 0.03%/C (0~50C) PROTECTION Over Voltage Protection Protection Type: Shutdown output voltage, re-power on to recover Above 105% rated output power. Overload Protection Protection Type: Hiccup mode, recovers automatically after fault condition is removed. Protection Type: Shutdown output voltage, recovers automatically after temperature goes down. Over Temperature Protection Tj 135C typically (U1) Detect on main control IC. GENERAL SPECIFICATIONS Switching Frequency (fixed) 100KHz Efficiency See Table Isolation Voltage 4000VAC (Input to Output), 1500VAC (Input to FG), SHORT (Output to FG) Isolation Resistance 100M / 500VDC (Input to Output), 100M / 500VDC (Input to FG) ENVIRONMENTAL SPECIFICATIONS Operating Temperature -10C to +60C (refer to derating curve) Storage Temperature -20C to +85C Operating Humidity (non-condensing) 20% to 90% RH Storage Humidity (non-condensing) 10% to 95% RH Vibration 10~500Hz, 2G 10min./1cycle, Period for 60 minutes each along X, Y, and Z axes. MTBF 547,000 hours min. (According to MIL-HDBK-217) at 25C PHYSICAL SPECIFICATIONS Weight 150g Dimensions 101.6(L) x 65.8(W) x 23.5(H) mm SAFETY & EMC Safety Standards UL2601-1, TUV EN60601-1, IEC601-1 Approved EMI Conduction & Radiation Compliance to EN55011 (CISPR11) Class B Harmonic Current Compliance to EN61000-3-2,-3 EMS Immunity Compliance to EN61000-4-2,3,4,5,6,8,11, ENV50204, EN55024, EN60601-1-2, Medical level, criteria A o Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 PSMPS30 Series Single Output Up to 30 Watts AC/DC Medical Power Supply OUTPUT VOLTAGE / CURRENT RATING CHART Model PSMPS-30-5 PSMPS-30-12 PSMPS-30-15 PSMPS-30-24 PSMPS-30-27 PSMPS-30-48 88~264VAC 120~370VDC Input Voltage Output Voltage 5 VDC 12 VDC 15 VDC 24 VDC 27 VDC 48 VDC Output Current 5A 2.5A 2A 1.2A 1.1A 0.6A Ripple & Noise 80mV 120mV 150mV 240mV 240mV 240mV Output Power 25W 30W 30W 28.8W 29.7W 28.8W Efficiency 72% 75% 76% 77% 78% 78% NOTES 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load, and 25C ambient temperature. 2. Ripple & noise is measured at 20MHz bandwidth by using a 12" twisted pair-wire terminated with a 0.1f and 47F parallel capacitor. 3. Tolerance: includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component, which will be installed into final equipment. The final equipment must be re-confirmed that it still meets EMC directives. BLOCK DIAGRAM DERATING CURVE STATIC CHARACTERISTICS Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 PSMPS30 Series Single Output Up to 30 Watts AC/DC Medical Power Supply MECHANICAL DRAWING Unit: mm AC Input Connector (CN1): Molex 5277-02 or equivalent Pin. No 1,2 3,4 Assignment -V +V Mating Housing Molex 2139 or equivalent Terminal Molex 2478 or equivalent DC Output Connector (CN2): Molex 41791-5 or equivalent Pin No. 1 2,4 3 5 Assignment FG No Pin AC/N AC/L Molex 2139 or equivalent Molex 2478 or equivalent Mating Housing Terminal Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 |
Price & Availability of PSMPS-30-12
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |